Home > Products > Tube Furnace
1200℃ High vacuum nickle base alloy tube furnace1200℃ High vacuum nickle base alloy tube furnace1200℃ High vacuum nickle base alloy tube furnace

1200℃ High vacuum nickle base alloy tube furnace

    Technical parameters of high vacuum nickle base alloy tube furnace:

    Working Temperature

    1150

    No. of Heating Zones

    Three

    Length of Each Heating Zone

    300-400mm

    Length of Uniform Temperature Zone

    500 mm (Minimum)

    Material of vacuum tight working tube

    Inconel 600 or equivalent Nickle base alloy suitable for above mentioned Temperature. Water cooling jackets on both ends of the working tube to be provided.

    Inside dia. of working tube

    100 mm (Minimum)

    Wall thickness of working tube

    5 mm (Minimum)

    Temperature uniformity

    ± 5(In Uniform Temperature Zone)

    Temperature Control

    By 03 Thyristors and 03 independent Programmable PID controllers (One for each heating zone), Minimum 8 Segments or other equivalent temperature controllers.

    Note: The temperature controllers must be selectable for all types of thermocouple.

    Safety Controller

    A safety controller must be installed in the furnace to shut off the furnace in case of temperature shooting due failure of temperature control

    Thermocouples

    03 K type thermocouples for controlling/ measuring the temperature of 03 heating zones and 01 K type thermocouple for safety controller, all housed in SS-304 sleeves. Each thermocouple to be fixed in the center of each heating zone while thermocouple for safety controller to be fixed near the thermocouple of central heating zone. The thermocouples should be installed in the furnace in such a way that they should touch working tube but should not be damaged during splitting of the furnace. 

    Furnace Body & Structure

    Main structure: MS Channels

    Outer Body: Hot part made of MS, powder coated (in furnace) with hammer gray, while Cold Part (Control panel and other) made of MS powder coated (in furnace) with green or blue paint.

    Material of Insulation: Fiber Ceramic Board and Blanket (Bricks made of heavy Ceramic must not be used).

    Vacuum System

    High vacuum to be generated by rotary vane pump and oil diffusion pump incorporated in a vacuum station. The valves in the vacuum station are to be operated manually.

    Two stage rotary vane pump: pumping rate: 5L/s; Ultimate vacuum:1x 10-3 mbar.

    Oil Diffusion Pump: pumping rate: 600L/s; Ultimate vacuum: 1x 10-6 mbar.

    Vacuum Gauge & Controller: Vacuum gauge fitted in the working tube should be able to measure the vacuum during heating operation of the furnace. Measuring range: 1x 10-9 mbar.

    Electrical System

    Heating: 380V, 3 phases, 50Hz, Approx. 45KVA

    Vacuum: 220V, single phase, 50Hz


    Disclaimer: The product introduction content (including product images, product descriptions, technical parameters, etc.) of this site is for reference only. As the update may not be timely, there will be some differences between the content and the actual situation. Please contact our sales staff to confirm. The information provided on this site does not constitute any offer or promise, and the company will periodically improve and modify the website information, without prior notice, please understand.

    Contact Us
    • E-mail: cysi@cysi.wang
    • Tel: +86 371 5519 9322
    • Fax: +86 371 8603 6875
    • Add: No. 820, 8th Floor, 1st Unit, 9th Block, Cuizhu Street, High-Tech Zone, Zhengzhou, Henan, China




    Follow Us

    Copyright © Zhengzhou CY Scientific Instrument Co., Ltd. All Rights Reserved    Update cookies preferences

    | Sitemap |       Technical Support: